HOW TO REPAIR DEEP CAR PAINT SCRATCH LIKE A PRO

God knows how much I laughed by watching this video 😂
This is the most ugliest car paint work I have ever seen. They are dressed like professionals, but all their steps to remove the scratch were like a novice mistakes. The last result speaks it all. 🤣

Not perfect, but so much better than before, thank you for sharing.

When you wash your car, it will become coarse again

Thank you for sharing.❤

Looks better but you can still see the scratch

Здравейте от България ли сте видях мартениците на ръката

I’m running from that garage when I see that gold watch. They can keep my car too 😂

And this is why I’m sceptical of doing this job myself 🙈

"Make sure to not touch with oily fingers"

continues to prep, sand and touch with oily fingers

Changer de métier bande de charlatans, vous faites vraiment de la grosse merde 🤢🤮🤮

Sorry guys but that was an awful job.
I bet the tail light has scratched dull areas too as you didn’t tape it off and came into contact with it a few times with the sand paper.

Fender flares ruined the paint on a truck I just bought, thank you for this video

I’m sorry but I still can see the scratch, it is much better than before because the black color by itself coverup a lot the scratch but is not perfect. I think I can do a better job if I fill up even more inside the scratch.

Reading through the comments as the video plays, you people made me hit the panic button and I thought I just flushed $35 down the drain. Is it a perfect fix? No. Is it still visible? Yeah, some angles more than others. Does it stick out like a sore thumb? No where close to how people are reacting in the comments.
Come on people its not a tiny Chip Foose in a box, its a fucking pen. The car you're trying to touch up probably isn't going to be winning any car shows. I think for what it is works at a satisfactory level. 3 weeks after applying i bet you start to not even notice it anymore

looks like the acetone fogged your paint around the scratch

🤣🤣🤣 i ktoś za to zapłacił ??

with closed eyes you cant even tell there was a scratch

Love how many people get on these videos and in the comments do nothing but talk shit. At least there are actually people who take the initiative to try to do something on their own. These people talking $hit probably have all kinda scratches and paint damage on their vehicles. Probably don't even know how to change their own oil let alone paint correction. Damn haters

Poor job

That scratch is still outlined must of been very deep. Good video

You are the man. I could probably do this on my own, but I'll pay someone to get this job done. However, this project is awesome for those who are very handy. Thanks for sharing.

My first job was a painters apprentice at a collision center. Uou want to try and feather the edges of the scratch so you don’t have high spots protruding above the new paint. Also lay the pad flat and use X strokes. A drop of dawn in the water also helps out while wet sanding.

Cars paint destroyed.

Pretty rough job. Sanded too large an area to start with. Only sand the scratch and a millimeter or two either side. Mask off both sides of the scratch then use a 00 paint brush to slowly build up the layers as many as you need. Sand flat with 2 or 3,000 then mask off again and brush on the clear as many layers as needed. Sand that close to flat with 3,000 then dead flat with 5,000 let it cure for a few hours then buff with a DA not a rotary. The more time you take doing this the better

How did u learn this? It's amazing.

What a waste of time

I think this is like anything else, you can only get the result of the tools you have. I don't like these pens a scratch will require more paint in one place and less in another. I think I would dab it on my figure and work the paint into the scratch. Let dry a good while then depending on how it looks it may need an additional coat. Next, as you did, wet sand until it's all level. Clean it apply a clear coat, polish, and enjoy. Thank you-

Terrible!

I can still see it 😓

I fill the scratch with similar color glazing compound using a rubber spatula. Then proceed as shown. Once the scratch is nearly filled, it is far less noticeable.

Title says “like a pro” proceeds to break out a touch up pen 🖊️

the scratch is 100% there .. wtf.

Disgusting voice useless work

To be honest , I would never bring my car to you to repair a scratch. . I use professionals .

* DONT WORK DONT WASTE YOU TIME *
Ummm.. I still see the scratch? It’s still very noticeable, just because it’s more shinny doesn’t mean better lol wasted my time. Don’t try this

As an FYI. With all 3M products, the color of the squirts spout is the color buffing pad you need to use, so since the squirt spout is black on your 3M bottle, you need to use a black foam pad with that product.

Take a shot everytime he says Guys, and you're lucky to last 5 minutes without going in a coma.

These guys sucks

Didnt sand to start with. Thats why its still there. You have to round the edges of the scratch first, then use the touch up paint, sand, then clear coat, sand again, then 2 step polish

Its a disaster. You repair like a kid 😩

Where’s your business located ?

In Russia, car scratch you...

Take one shot for every "guys" 😅

Sanded area is looking white discloured and very bad

Good advice, though the scratch is still VERY visible at the end.

For the Moment much netter thanks before. But its only a 1K Paint, so how does it Look in 1-2 years 😅

How you get it to dry fast enough ?