Making a quick dbw pedal bracket for mustang

Are you still making springs to go with your best cam?

Easy,simple, effective. Doesn't get any better than that.

I never thought I'd say this, but... This is not a turbo going on a shit box 4 cylinder from 1973. 😞

🤣

Good information thanks for sharing

Look at the 2009 Impala SS pedal. They fit nicely into many cars.

It'll never work. Buhhh welds bruhh...

👍👍👍

Stock Barra pedal was the same, with an offset to the right. Thanks for sharing looks like I am going to find one and make bracket design #3!

Beautiful good sir!

Not sure how to request a video?but was wandering if you could do a video on how to make cam chop with Holley terminator. Timing and fuel. Thanks.

Sloppy you need to test HHO generator. why can't there be a 20+ MPG 800 RWHP car....

Hey! Can you do a video on ms3 gold box vs Holley comparison with pros and cons?

Interesting tidbits, thanks! Good video! Can I interest you in some non copyright music in my non copyright music playlist?

Hey guys doy think 33 degrees @wot on a stock block 5.3 cam and headers with a 200 shot plate system on e85 with BR7EF spark plugs is too much?

Which setting/calibration do you use for this pedal in the Terminator/Holley software?

can you change out these 2 different pedals and still use the factory PCM and Tac Module that came from the donor vehicle ( came factory with the plastic pedal )

Does this Peddle work with Gen 4 Ecm?

I'm running into the same issue on my fox body. I think I might just cut and reweld the truck pedal. It sure is made out of some thick steel