1st gen cummins dyno 450hp 1008 ft lbs

nope nothin real serious done to this 12mm pump, just basically maxed, it was a strong running pump though. Not sure, I just bought the pods brand new from Gillette Diesel a few years ago and been running them since. Since the 307 run, i've added an airdog, more timing, and this built 47rh made a huge difference and actually got my power to the ground. A lot has changed on this truck over the past few years.

Its now got a whole new fuel setup, more air and more timing, the new setup should blow this dyno setup out of the water. Pop tested the ol PODs and they were all a little bit lower than new, but they were all even, then had em sold in a week. I need to get it on the rollers again, the trucks just too busy pullin instead.

What did you have to do for the 47rh swap I'm about to do one and need to know the specifics

I'm building my 93 right now and I would like to make numbers like that... just a good daily driver nothing crazy message me I'd like to talk to you about some of the things you did with the pump injectors timing etc mostly fueling thanks

HOW MANY POUNDS OF BOOST

thats a generous dyno for sure.

this is where i want to be with my 92.
silly question but how do you ID a transmission on a 1992 W250 4x4
ive heard that might an A518, , A618 47RE, 47RH, or torqueflight 727 with a overdrive
is there any special place on the transmission that would tell me this
all i want to do is replace/upgrade the torque converter because the current one doesn't feel like its putting the power to the ground like it should

what size of injectors