Ignition Latency (Spark Timing Error)

Thanks again for the great video Andy. Could you maybe share which Picoscope and which Accessories (partnumber) you used for probing the Tooth and Ign signals?

Another Andy video! I have plan my viewing time, many notes taken during these awesome courses, thanks again!

Great vid, definitely will have to look into this!

Really helpful! Tons of important info!

Great info ....Thanks Andy👌🤞

Hello Mr.Whittle am regular viewer of your videos and I have seem them all but I have a question that am sure you will be able to answer some engines like the Nissan qr25de found in a lot of Nissans such as the xtrail and sentra vspec use a continuously variable cam timing which is very different from vtech and vvl so I was wondering if there was a way to control it using megasquirt ECU by means of pulse with modulation thanks

great video ! but how does the "0.7" degree delay come out when 750 rpm, I can't understand ??? Does the 165 micro sec is a standard?

Carburetors are a bit wasteful but make this much less of an issue. All though that is probably due to the excess fuel during the lean periods and the ability to change a jet or emulsion piece for fine tuning of the increasing demand with rpm.

What is an appropriate timing light?

Hey can you help me !?!?

I am very curious about spark latency with a gm TBI distributor and the different 369 and 048 ignition control module have built in latency and timing control. What i think im experiencing is a cross fire or cross spark issue in the distributor cap because of a spark latency issue at a higher timing advance.

Andy, it's the guy from Florida. When you say you have to reset ignition base timing after inputting the latency, are you referring to the timing in the ignition table or the timing when phasing the distributor rotor?
Good video as customary, i understand what you were talking about💪🏆

I have another question, with the engine running, timing fixed and a timing light on the crank, can we simply increase or decrease the latency time until the crank and computer ignition degrees match?

Thanks