How To Disassemble & Reassemble the Extruder on the Maker Select Plus

Hey bv3d how long did it take you to build the monoprice select maker 3d printer I be getting my soon

Thanks for sharing Bryan, great stuff as always!

nice instructions Bryan!

Great stuff Bryan. "Un-disassembled" 😂 Also, do you have a 'smoother' on the extruder? Cheers, JAYTEE

Thanks Bryan! I've had my extruder off several times, but this video helped push me to upgrading my firmware. I really will do it one of these days!

Man, that printer is WIDE!

I think a video about nozzle cleaning would be great, and potentially hilarious!

where are those links you pointed to? I see them in the Show More, but not on the screen?

Thank you for putting me in the roll credits! That's fantastic!

Where can I find that bed for the printer? Also an amazing video!

what type of nozzle do i need to buy need a new nozzle will any nozzle work

video is a life saver thank you!


my extruder stepper keeps getting the filament wrapped around the gear and arm and everything else. is there a good fix to this?

I love your channel and appreciate all the contributions you have made to the monoprice community. I am a beginner tinkerer and your videos have given me the confidence I needed to do all kinds of mods to my MP select. I was hoping that you may consider doing lead screw install upgrade on your channel. I print dnd miniatures but have noticed banding and other artifacts that are consistent with a less than perfectly straight threaded rod. I appreciate all your work and hope you consider it.

I would really appreciate a video of the nozzle teardown. Mine has a terrible clog and even better yet, I broke off the end of my wire attempting to clean it out...

I am hoping this will show me what parts I need to replace to get mine working again. I got a large globbed ball around the whole assembly and I don't know what I was doing. Pretty sure I screwed it up, while I went in blind taking it apart. All because the bed was not level. darn.

I tried using the 0.4mm bit to enter the nozzle and "extract" said filament. I was extremely careful and as soon as the bit went in.... It broke off inside the nozzle. Not sure if it is still in there or not. I have since been able to print one of the pre-loaded images that came with the printer. I may want to look into replacing my nozzle in the near future. Good video by the way.

You just saved my printer. Thank you!

Hi Brian, one of my x-axis rods tends to slip out sometimes during a print. Could you show me how to do proper maintenance on it, including something for the tensioning belt?

I’m a little confused because I have a voxelab aquila

Video to remove extruded. You didn’t put a link

Do yoiu have a video on how to change tie Y-AXIS linear bearings? Thanks