How To: Installing Hangerless SpanTrack by UNEX Manufacturing

Hangerless SpanTrack carton flow is an adjustable length track that sits on the ledge of step beams in front and rear, keeping the face of the beams clear.

Build a SpanTrack solution in minutes: https://config.unex.com/
Learn more about SpanTrack Lane: https://www.unex.com/carton-flow/spantrack-lane/
Download Installation Guide: https://www.unex.com/resources/installation-guides/

Hangerless SpanTrack can be added to any standard pallet rack with step beams. Track sections are supported by the front and rear step beams. For each type of carton, install the first level of track following the instructions below and test for pitch before installing additional levels.

1. ADJUST BEAMS: Set front pallet rack beam to desired discharge elevation. Set rear beam at higher elevation for flow. Recommended pitch is 1 inch for every 1 foot of rack depth. (Example: 4-foot deep rack would require the rear beam to be set 4 inches higher than the front beam).

2. ADD TRACK Adjust and tighten the two bolts holding the rear extrusion in position such that the track fits snugly between the steps of the step beams.

3. TEST PITCH Test installed track section for product flow to determine if rear beam needs readjustment for effective pitch.

IMPORTANT: Track section to be tested should be loaded and allowed to sit for 24 hours. Then remove cartons at pick face and check resulting flow. Testing is the most reliable way to ensure proper flow for your particular products and storage environment.

UNEX SpanTrack carton flow is the most reliable and durable carton flow solution in the material handling industry.

Тэги:

#unex #unex_manufacturing #material_handling #Material_Handling_Equipment_(Industry) #how-to #span-track #carton_flow #order_picking #Manufacturing_(Industry)

Скачать видео